Edger Repairs in Beaconsfield

Lawn edger won't start, blade gone blunt, or shaft making a horrible noise? We'll sort it. Free pickup from Beaconsfield on Saturdays, back to you Sunday.

Book Online Call (08) 9444 1284
Free Saturday pickup from Beaconsfield. Sunday delivery back to your door.
50+
Years in Perth
All types
Petrol, electric, battery
7 days
Typical turnaround
30 day
Workmanship guarantee

How it works

No need to load the edger into the boot or chase down a workshop. We come to Beaconsfield, take it back to the bench, fix it properly, and bring it home.

STEP 01

Book online

Pick a Saturday pickup slot through our online booking. Takes about a minute.

STEP 02

We collect

We swing past your place in Beaconsfield on Saturday and pick up the edger. Free.

STEP 03

Bench service

Strip, diagnose, repair and test on the workshop bench. No guesswork.

STEP 04

Back to you

Delivered back to your door Sunday, ready to cut a clean line again.

What an edger service actually involves

Edgers cop a hammering. Concrete, limestone, the odd reticulation pipe. Most of them come in with two or three issues at once, not just a blunt blade. Here's what we go through:

Blade inspection & replacement

Edger blades wear fast on Perth's limestone driveways. We check the edge, the mounting, and replace if it's chipped or under spec.

Shaft & bearing service

Sand and grass clippings get into the shaft over time. We strip it, clean the bearings, regrease, and check for play.

Drive belt replacement

Belt-driven edgers stretch and slip. If yours is slow to spin up or screeching on startup, the belt's the usual culprit.

Carburettor clean & rebuild

Two-stroke edgers sitting over winter gum up fast. We strip the carby, clean the jets, and replace gaskets and diaphragms as needed.

Fuel system service

Old fuel, blocked filters, perished lines. Cheap to fix, but it's why most edgers won't start after a long break.

Full diagnostic & tune

Spark, compression, ignition timing, idle, throttle response. Same diagnostic process we've used for 50 years.

A note for Beaconsfield edger owners

Beaconsfield is a mix of heritage homes, working-class blocks, and renovated terraces. Smaller block sizes than the outer suburbs but every one needs edging done. Plenty of tight access driveways and limestone walls that punish blades.

Most Beaconsfield edgers come to us because they've been used hard but not maintained. Once they get a proper service they tend to keep running for years. Just need someone to actually look at them.

Brands we service

Atom · Honda · Masport · Stihl · Husqvarna · Victa · Bushranger · Echo · Shindaiwa

If it's a petrol, electric or battery edger and it's broken, we can have a look. Doesn't matter where you bought it.

Your spark plug is trying to tell you something

Pull the plug out of any edger and the colour tells you exactly what's going on inside the engine. Most people never look.

This is the cheapest diagnostic tool in your shed. A 13mm or 19mm spanner, depending on your edger, two minutes of your time, and you can spot a problem six months before it leaves you stranded.

Here's what to look for on the electrode and porcelain:

  • Light tan or biscuit brown. Engine's running right. Put the plug back in and forget about it for 25 hours.
  • Black and dry, sooty. Running rich. Could be a clogged air filter, choke stuck on, or a carby out of adjustment. Easy fix usually.
  • Black and oily, wet. Too much oil in the mix, or the carby is dumping fuel. Check your two-stroke ratio first. Should be 50:1, not 25:1.
  • White or pale grey, almost clean. Running lean. This one's bad. The engine is starving for fuel and running too hot. Stop using it before you melt the piston.
  • Black and crumbly with a coating that flakes off. Carbon buildup from old fuel or wrong oil. Time for a service.

While the plug is out, check the gap. Most edger plugs want 0.6 to 0.7mm. You can buy a feeler gauge from any auto shop for about 5 dollars. If the gap's wrong, the spark is weak and you'll get hard starting and rough running.

One more thing. Spark plugs aren't lifetime parts. They wear out. If yours has been in there 3 or 4 years, just chuck a new one in. They're 8 to 12 dollars and it makes a noticeable difference. NGK BPMR7A is the go-to for most edgers, but check your manual.

Why Sandersons

50 years in

Family-owned outdoor power equipment specialists since 1975. Same family, same workshop ethic.

Honest quoting

We diagnose first, then ring you with the cost before any work goes ahead. No surprises on the invoice.

Free pickup & delivery

Saturday pickup, Sunday delivery, no charge. Makes the whole job easier than dropping off yourself.

30-day workmanship guarantee

If something we serviced isn't right, bring it back. We'll fix it.

Common questions

Do you really pick up from Beaconsfield for free?

Yep. Saturday pickup, Sunday delivery, no charge. We've been running this through Beaconsfield and the rest of Perth for years.

How much does an edger service cost?

It depends on what's wrong with it and what brand you've got. Once we've had a proper look on the bench, we ring you with a fixed price before we do any work. No charging by the hour, no surprises.

My edger won't start. Is it worth fixing?

Almost always yes. Most "won't start" jobs come down to old fuel, a gummed-up carby, or a tired spark plug. None of those are expensive fixes. We'll have a look and tell you straight if it's not worth it.

How often should I service my edger?

Once a year for most home edgers. If you're a tradie running it daily, twice a year. Sand, salt, and dust are hard on bearings.

Do you service electric and battery edgers too?

We do. Battery edgers don't have carbies to worry about, but the shaft, blade, drive system and electronics all wear and we can service the lot. EGO Power+, Stihl battery, Honda battery, all good.

How long does it take?

Usually back to you within a week. Picked up Saturday, delivered the following Sunday at the latest. If parts have to come in, we'll let you know.

How do I book?

Easiest is the online booking on this page. Pick a slot, leave your address, done. Or ring us on (08) 9444 1284 if you'd rather talk to a person.

We also service edgers in nearby suburbs: Fremantle · North Fremantle · South Fremantle · East Fremantle · White Gum Valley

Edger needs sorting?

Book a free Saturday pickup from Beaconsfield. Back to your door Sunday, cutting a clean line.

Book Online